Xbox 360 Hack: Flash Lite-On Drive Download Link JungleFlasher Tutorial for 1.70b *PDF* http://bit.ly/d5H2to Download Link LiteOn_iXtreme_v1.61 http://bit.ly/cWaYJw Download Link JungleFlasher.0.1.67 http://bit.ly/b4B6x4 Xbox 360 Disassembly Tutorial http://www.llamma.com/xbox360/repair/Xbox-360-Disassembly.htm How TO DOwnload : Just Put SOme Fake Infos. And Fill The Surveys and Get The Download Link CAP: http://www.eternj.net/wp-content/files/2009/11/JungleFlasherDVDKey32.jpg http://www.eternj.net/wp-content/files/2009/11/XboxDisassembled.jpg Instructions: Download JungleFlasher v0.1.67 beta package and unrar it to a folder. Download iXtremem 1.6 firmware for Lite-On 83850C from iXtremem.net. Unrar the file and put ix16-liteon838.bin file in the firmware subfolder in the JungleFlasher v0.1.67 beta folder. Install PortIO32 on your PC. PortIO32 installation files are included in the JungleFlasher v0.1.67 beta package. Open Xbox 360 (follow instructions from Xbox 360 Disassembly Tutorial). Connect an SATA cable from your PC motherboard to the Lite-On DVD drive. Use Xbox 360 console to power the drive. Run JungleFlasher v0.1.67 beta on your PC. Click the DVDKey32? tab. In the I/O Port dropbox select the port corresponding to the Lite-On drive. Note when you select the correct port, the Drive Properties section will show the Lite-On drive information (double check this!!!). Then click LO83Info button. JungleFlasher will pop up a window and ask you to power on the DVD drive with tray half open. This is the tricky part and here is how you do it: 1) Press the eject button so that the DVD tray is fully open. 2) Disconnect the power cable to the DVD drive. 3) Push the tray half in. 4) Reconnect the DVD power cable (VERY IMPORTANT: make sure you dont connect the power cable connector upside down. Otherwise you are going to bust your DVD drive). Once the DVD drive tray is half open, click OK button in the popup window. JungleFlasher will then send the LO83info command to the drive. Within a few seconds, JungleFlasher will pop up another window and ask to you fully open the drive tray. Manually move the tray fully open by hand. Then click OK button. If JungleFlasher thinks the key dump is valid, it will prompt you to power on the DVD drive with tray half open again. Follow the procedure in Step 8 and make sure the DVD drive is powered on with tray half open. Then click OK button. Once again, JungleFlasher will ask you to set full open tray. Manually pull the tray to fully open position and click OK button. JungleFlasher will prompt you to save a few files (Serial.bin, Identify.bin, Inquiry.bin, and Dummy.bin). If you checked the Dummy.bin Only box in the DVDKey32? tab, you will be prompted to save only Dummy.bin. Save the file(s). Once saved, JungleFlasher will load Dummy.bin as Source Firmware in the FirmwareTool32? tab and prompt you to auto load iXtreme firmware. If you selected Yes, target firmware will be loaded and automatically spoofed. Note: Try dumping the DVD drive key a few times and compare the dumped keys. Make sure they are the same before erasing the Lite-On drive. code pour embarquer la vidéo : >>> http://www.youtube.com/embed/VxWgd8R06lo <<< |